Pic of 5BW engine bay

[jbawden]

I'm looking for a picture of the 5BW engine bay with the plastic engine covered removed. I need to see the factory routing of a few lines. Anyone have one?

 

[Sully]

Let me know if you need a wider shot

 

[jbawden]

Let me know if you need a wider shot

Thanks bud!

Nice lid, who makes that?

 

[Sully]

Thanks bud!

Nice lid, who makes that?

Ty, MPI

 

[sleepys4]

Let me know if you need a wider shot

MPI lID looks sick! May have to get rid of my LMP lid for one.

 

[Yo Nadz]

View attachment IMG_4856.jpeg

 

[hawk02]

Here's my engine bay. No special lid but I did replace the plastic cover with a carbon fiber one from LightWurkz. I also applied Cerakote Trimcoat to all the plastic pieces.

 

[Tall Steve]

Here's my engine bay. No special lid but I did replace the plastic cover with a carbon fiber one from LightWurkz. I also applied Cerakote Trimcoat to all the plastic pieces.View attachment 26633

That looks good!

 

[sleepys4]

Always a work in progress.

 

[flipray]

Here's my engine bay. No special lid but I did replace the plastic cover with a carbon fiber one from LightWurkz. I also applied Cerakote Trimcoat to all the plastic pieces.View attachment 26633

Cerakote doesnt get "sticky" and attract dust?

 

[hawk02]

Cerakote doesnt get "sticky" and attract dust?

Nope.

 

[FLYARMY]

I used Cerakote on all the exterior plastic trim of my Dodge Challenger and it works fantastic and has lasted one year , so far. Takes that old gray out makes it look new.

 

[flipray]

Cleaned it up some by rerouting lines and harness.

 

[OldGoat]

Always a work in progress.

Whose air intake? 103 throttle body? Is intake boot larger diameter? Stock boot is a real pain to get over 103 body

 

[flipray]

Whose air intake? 103 throttle body? Is intake boot larger diameter? Stock boot is a real pain to get over 103 body

Looks like Cordes, just wrapped in heat film.

 

[OldGoat]

View attachment 27250
Cleaned it up some by rerouting lines and harness.

Looks awesome, did you do your own install? I see pulley mandrel and 103 Kateck TB. Blower housing ported? How many miles and did you have much oil in manifold. Did you consider catch can? Lastly what pulley size did you go with. Thanks

 

[hawk02]

View attachment 27250
Cleaned it up some by rerouting lines and harness.

Is that the DSX lid?

 

[flipray]

Looks awesome, did you do your own install? I see pulley mandrel and 103 Kateck TB. Blower housing ported? How many miles and did you have much oil in manifold. Did you consider catch can? Lastly what pulley size did you go with. Thanks

Yup, running slight underpulley 2.3, Kong X-port, Katech 103TB, DSX Lid and already running a MM Wild can on the bottom right. Just recently got it fully tuned and working on getting an intake and flex fuel installed next.

Is that the DSX lid?

Yes sir, powder coated Cherry Illusion iirc with the stock Blackwing lid engraved stencil on it.

 

[wickedowesix]

View attachment 20240807_145813.jpg
View attachment 20240807_150523_resized.jpg

 

[OldGoat]

Carbon fiber valve covers, real or film?