CT4 BW Help with spacers

[Hollandca12]

Hello,

I need some guidance/assistance. I purchased a used 2023 BW with 15mm wheel spacers placed by the prior owner. I'm running into a snag trying to remove the lugs hold the spacers onto the hub. They don't seem to budge despite using a with a squirt of WD40 , breaker bar, or impact wrench. There's no visible rust or corrosion. My assumption is that someone obviously over tightened. Any tips or trick would be appreciated.

Thanks,
Courtney

 

[Steelwing]

They probably used threadlocker on the nuts. Might need to use heat to melt it.

 

[rubberduck]

How long a breaker bar are you using? If you have a ~30in one that should produce at least 300 ft-lb torque. If some dummy used thread locker then heating may be necessary, a heat torch possibly.