Search results

took 'em long enough LOL

have you checked out CPD? https://www.instagram.com/crestperformancedynamics/?hl=en

on the topic of these rear middle seat belts I went to fold my seats down, so I pressed my key into the middle seat belt release that makes it a 3-point harness. The thing popped out just fine but the belt will not retract all the way up to the trunk where the mechanism is. What do I do to...

Welcome to the forums all the way from the USA :beer

how?

Chased down and resolved the rattle coming from near the sub and under the child seatbelt plate. Used some foam and electrical tape wrapped around a toothpick to stuff the small gaps that were making all that noise. Now I can enjoy music at all volumes.

^^ rear - I have used the cradle brace area where the orange arrow points to with no issues so far - lift from pinch weld then lower onto the structural brace -------------------------------------------------------------------- front - put some duct tape down so you don't scratch the surface...

Send the pics!!!!

I can't make it this time around but sounds like a ton of fun

@XTRMLN Thank you for your insights. I have the green filters installed as well and an exhaust kit on pre-order from crest. Next steps after that are a ported TB, colder plugs, and eventually some resonated downpipes. I am leaning towards a dedicated unlock & tune, although the ability...

If you were to go back in time and do your tuning process all over again, would you still start with the JB4 module or go straight for the HP tuners unlock & tune? I enjoy the concept of a removable JB4, but worry about reliability.

Originally, I was holding out for a Corsa extreme or an AWE track system, but I had to have one of these when I chatted with the fabricator. So far, the customer service has been top notch What really impressed me with Crest's design was the ability to bolt in a mid section with resonators if...

Just ordered the crest race exhaust on pre order. No resonators 😏

I found the same youtube video -- was super helpful for the smaller airbag clip on the bottom in the end I could not break the torx T50 loose on mine, even with mild heat applied. As soon as I started to see the beginning signs of stripping, I called it quits. This thing is in there and will...

Can't wait to hear the different setups under load. Impatiently waiting until July 🍿

Went in for an oil change/maintenance The dealers are all messed up with this CDK ransom situation. Unable to pull customer data, access records, etc. It even looks like the provider CDK may pay the hackers to make it stop. I got a nice, handwritten receipt to file in my 3-ring un-hackable...

Dealer inspected everything during my last oil change. Everything was good to go

this is the only start/stop mod that I have seen https://www.paragonperf.com/Interior_c_138.html (I would imagine the 5BW and 4BW share the same start stop button)

getting close to the ground helps a lot for a stationary vehicle when someone is hauling ass I like to get a bit higher up and capture the fly by. NJMP has a great spot up in the timing tower on the straight for this (thunderbolt)

hammer that link fellas we need this