Recent content by BWDudeBro

Does it seem to be isolated more in the front or the rear?

Yeah, i worded that poorly. I meant to say that it wasn't immediately obvious where the jack stand would go if you used the lifting block for the jack. Or where the jack would go if you intended to use the lifting block for a jack stand. I have since figured it out it works great for both the...

Coming back with a rare "I think I've got this one figured out" update. Hope this helps someone in the future. My thought from July was correct - The Powerstop pads rattling in calipers over bumps. I removed each front pads and applied an even coat of CRC Disc Brake Quiet across the entire...

Finally saw a fellow 4BW here in midtown ATL yesterday. Black w/ bronze wheels and chrome badges getting onto 75 South. You around here?

For those playing along at home, I'm now 95% sure my noise is due to my front Powerstop pads being cut too short. Without the brakes applied, small, sharp bumps between 20-40mph will cause the pads to move vertically inside the calipers. The noise is likely the pad top and bottom edges rather...

Sold!

Blue Ridge Parkway always goes down smooth. In this case, not literally - the pavement is worse than when I was there two years ago for sure. But still - the car is perfect for this trip. It eats up the hours of highway travel to get to the good roads, then you just fiddle with the drive modes...

Interesting. That definitely describes my issue, but after this weekend I'm inclined to try the brake pads first (see above). But yeah, that's just the bottom of your mag ride damper. Can you see an active leak? If not it's hard to tell if that's coming from the damper itself or perhaps...

Yep, good call... I initially suspected this since my truck has this bad, but thought for sure these calipers wouldn't have an issue since my Mustang Brembos never did. After posting this, I drove the car 400 miles this weekend, and noticed a pronounced *click* about half the time I applied the...

I was able to solve this one. The trim around the third brake light is separate from the rest of the headliner, and just pulls out with clips. Once under there, the plastic bracket holding the third brake is visible. It's bolted to the roof of the car and didn't move much. However, a separate...

I successfully diagnosed this issue finally and was very proud until I came back here to post about it and remembered that you had suggested this months ago. This was indeed my issue. While i can induce a buzz by thumping on the decklid, all the noise I hear over bumps is from the headliner in...

I will gather more detail as I continue to hear this, but wondering if anyone else is experiencing similar issues. My 4BW has ~3700mi and I'm getting a pronounced "extra" noise as the front suspension cycles over sharp impacts. It's tough to reproduce, so I can't yet tell if it's isolated to...

Awesome, i'll DM you!

Funny... My work one-upper got my Electric Blue in a Guard's Red Porsche GT car as well... but his is "just" a GT4.

Although I purchased the recommended jack pads from this thread, I ended up pivoting and followed another method instead. Some of you may have seen the other thread on how to adapt ZL1-style pads to 4V BWs with minor trimming. Someone else took the plunge and I followed in their footsteps. I...